Ask Experts Questions for FREE Help !
Ask
    dryerproblems's Avatar
    dryerproblems Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 8, 2009, 04:21 PM
    How to you remove the back panel on a maytag neptune drying center
    I am trying to replace the thermal fuse on my maytag neptune drying center model MCG8000AWQ and I can't figure out how to get access to the back of the dryer. I have removed every screw I can get to but still cannot remove the panel. Does anyone know how to remove the panels? Thank you for any help.
    szthatsme's Avatar
    szthatsme Posts: 2, Reputation: 1
    New Member
    		  
    #2

    Jan 1, 2010, 02:20 PM

    You have to take the "front panel" off. Remove the door and the two screws on opposite side of door hinges and the panel will come forward and lift off giving you easy access to the fuses
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Maytag Neptune dryer (MDE4000AYW) is not drying clothes [ 0 Answers ]

I have a Maytag Neptune Dryer(model# MDE4000AYW) which does not dry clothes. I see that cool air comes out of duct. Have tried to clean the vent and it seems fine. Any idea ?

My Maytag Neptune MDE4000AY Dryer is not drying properly [ 1 Answers ]

W dyer takes two 60 min. cycles to dry load of clothes. Dyer element warm not hot. How do yor replace element

Maytag Neptune dryer not drying well. [ 6 Answers ]

I have a Maytag Neptune dryer and it doesn't dry well at all. I am used to putting big loads in it and I don't know if it's too big of loads or what but like 7-10 pairs of jeans and it takes at least 5 hours to dry them... if then. The sensor seems to work but shuts itself off before they are...

View more questions Search