Ask Experts Questions for FREE Help !
Ask
    beachbum2004's Avatar
    beachbum2004 Posts: 1, Reputation: 1
    New Member
     
    #1

    Aug 10, 2009, 07:14 AM
    Replacing dryer belt whirlpool model LGR7648KQ1
    I have to replace the belt on my Whirlpool dryer model no. LGR7648KQ1.

    The dryer has a single front panel (no separate, pull-out bottom panel). How do I access the idler pulley, etc. Must I tip the unit on its back and then remove the front panel to slip the belt around the drum, etc. Thanks.

Check out some similar questions!

Replacing lower drive belt on Troy Bilt Model Y609H. [ 5 Answers ]

Followed manual instructions exactly. Everything worked fine until I removed the electric PTO clutch. Cannot remove old belt or install new belt on the engine pulley because of three tabs around the pulley that are in the way. Tried to remove engine pulley with a wheel puller but it will not...

Replacing a dryer belt [ 1 Answers ]

Hi, I replaced my dryer belt. Now the dryer turns again but if I put clothes in it will not turn. I was told I probably have to increase the tension on the belt. How do I do this. I assume it is by adjusting the idler pulley Thanks

Whirlpool Gas Dryer (MDL # LGR7648KQ1) [ 20 Answers ]

My Whirlpool Gas Dryer (MDL # LGR7648KQ1) is not drying properly. The unit will heat up initially but after a while it will not ignite. I've taken it apart and run it without the drum. It ignited properly 3 times. With the unit reassembled the dryer will ignite on startup but not reignite...

Whirlpool duet dryer '07 model [ 1 Answers ]

The lite on the left bottom of the dryer is lit that says "control lock" which prevents the dryer from turning on, I cannot get it to shut off. Any knowledge on this? I do not have a manual. Thanks


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.