Ask Experts Questions for FREE Help !
Ask
    bear52's Avatar
    bear52 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 12, 2014, 10:35 AM
    Maytag dryer won t start
    Pressing start button motor sounds like it wants to start but won't turn the drum. This is an intermittent problem.
    parttime's Avatar
    parttime Posts: 1,440, Reputation: 113
    Ultra Member
     
    #2

    Jan 12, 2014, 05:05 PM
    Ok bear, when the dryer doesn't start what do you do to get it to run?
    drtom4444's Avatar
    drtom4444 Posts: 3,282, Reputation: 145
    Ultra Member
     
    #3

    Jan 13, 2014, 05:01 AM
    Driers will do that when the lint builds up like concrete on the inside of the air ducts and the lubrication dries up, plus you have a safety that is opening and failing to close when it cools down. It’s so full of dirt the next thing it will do is to catch on fire and burn down your house. Also, the sensors get blocked from sensing when the dryer is dirty. You have to totally tear it down piece by piece. Halfway cleaning it will not work because all it takes is one clogged up air passage or dirty sensor. You need to totally tear it down and scrape out and wash all of the parts except the motor, which you vacuum out. You can go to YouTube to see videos on how to take it apart, but do a very good job or it will fail again quickly. I would get a new belt and change it while you have it apart and get some white lithium grease and grease any bearings you find. The support rollers are greased by pulling the pin and greasing it and greasing the inside of the roller. You need to clean out a drier every two years, at least, according to the manual. You just unplug the wires from the sensors and remove ductwork that they are attached on and clean the entire thing with soap and water. Make sure you go all through the dryer and get all parts like the blower fan and housing (it has to be scrubbed and washed out), vacuum out motor well and clean exhaust. Mark all wires you unplug so you know where they go. If you leave any dirt in the ducts it will blow another fuse quickly or will not maintain the temperature correctly. This is an easier job than you would think. Make sure to clean around all of the sensors, if it has them. Also, change the belt while you have it torn down so you won’t be doing it later. See: Dryer vent cleaning prevents fires - YouTube and: Cleaning out a dryer with top lint cleanout - YouTube
    Cleaning out a dryer: By a woman 2 of 2 - YouTube
    Here are some manuals: https://dl.dropboxusercontent.com/u/...g%20Dryers.zip

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Maytag dryer won't start [ 1 Answers ]

Hello, I have a Maytag Performa dryer. It quit mid cycle and won't start. I don't hear the timer, I tried the circuit breaker and that's not it. What should I do?

Maytag dryer won't start de806 [ 1 Answers ]

Maytag dryer suddenly stopped working. Have manual and indicated it might be timer. Cannot find timer part anywhere online. Does anyone know a source? Or is it possible it might be some other problem? Door switch seems to work OK Thanks

Maytag Dryer MDE5500AYW won't start [ 0 Answers ]

The dryer doesn't do anything. The only thing that is operational is the interior light. There currently isn't even a display on the controls. Checked the incoming power which is OK. Any suggestions?

Maytag LDE482 Dryer Won't Start. [ 1 Answers ]

I recently moved my Maytag LDE482 Dryer to replace the floor. When it was moved back, it wouldn't start. I have checked the connections and the cirucit breaker and they are OK. What could be the problem? Is there a safety switch that has been tripped?


View more questions Search