Ask Experts Questions for FREE Help !
Ask
    goinalone's Avatar
    goinalone Posts: 1, Reputation: 1
    New Member
     
    #1

    Jun 10, 2007, 01:02 PM
    Kenmore washer hangs up
    I appear to have a problem similar to big_lar who posted on April 12, 2006 01:04PM. I have an old Kenmore, model 110.26822692, purchased in '78. The washer fills up and aggitates until the spin cycle, then stops. The motor doesn't continue, the machine just stops. One can advance the cycle manually by turning the machine off at the cycle knob, advancing the cycle knob a click, and restarting. Then it continues through the end. This has been going on for many months. Lately it's occasionally hung up later in the cycle too. The machine was repaired several years ago for the same problem, but I don't know by whom or how, though it appeared to be a quick fix. I'm reluctant to replace the machine because the new models, the one's I can afford, don't wash well. Thanks for any advice.
    esquire1's Avatar
    esquire1 Posts: 2,483, Reputation: 209
    Ultra Member
     
    #2

    Jun 10, 2007, 02:01 PM
    Sounds like a bad lid switch

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Kenmore washer [ 1 Answers ]

Recently my washer stop agitating and spinning (Kenmore 110.92588210). It will fill and drain only. I replaced all broken dog cams and still no agitate or spin. What else would cause it not to work? :confused: And is this model a belt drive or direct drive?:confused: Any help would be...

Kenmore washer [ 1 Answers ]

I can't get the main control knob off to get the timer changed

Kenmore washer dryer combo 110-92966-102,washer agitates for a little then it stops. [ 0 Answers ]

Kenmore washer dryer combo 110-92966-102, The washer will fill and it will agitate for a little bit for about a minute, then it will stop before finishing.When it stops there is no motor sound.No matter what I set the knob to it will not start up again,but if I wait several minutes it will...

Kenmore washer [ 1 Answers ]

We have drain problems with our Kenmore washing machine. It's a basic 2 cycle washing machine. Because of the elevation of our septic system the builders had to have the washer drain first into a pump tank which then pumps it up and into the exit drain for our septic system. Anytime that the...

Kenmore 70 Washer [ 1 Answers ]

The washer does not spin. How do I remove the top. Any other advice?


View more questions Search