Ask Experts Questions for FREE Help !
Ask
    jriggs's Avatar
    jriggs Posts: 1, Reputation: 1
    New Member
     
    #1

    Apr 7, 2008, 08:32 AM
    Kenmore thermostat
    High temp. thermostat keeps going bad on my kenmore dryer. Thermal fuse has not gone bad yet. Only the high temp. stat. goes bad have checked all other stats with ohm tester. Dryer is not but a year old. Clean of lint. Afraid it may be bad wiring. Any ideas.
    Credendovidis's Avatar
    Credendovidis Posts: 1,593, Reputation: 66
    -
     
    #2

    Apr 7, 2008, 09:13 AM
    Have you checked the free air flow out of the dryer? If not sufficient air can flow through the dryer, the temperature goes up and the thermostat cuts out.
    .
    Are you sure that the dryer is not just running in energy saving mode?
    .
    In that mode the drum and heater cut off for a couple of seconds every ten or so seconds during the drying cycle. That is normal and intended : the water inside the clothing can still evaporate, while no energy is required for motor and heater.
    For more advice I need more details!

    :rolleyes:

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Model # of Kenmore Elite Catalysts Washer set to Kenmore 110.60936990 dryer from 1999 [ 3 Answers ]

I am experiencing weird problems with my top of the line Kenmore Elite Catalysts washing machine. I bought the washer and dryer as a pair for about $1700 in 1999. The dryer model # is 110.60936990 but the sticker has worn off the washer so I do not know the model #. I think it could be...

Thermostat turns on furnace and then thermostat shuts back to HOLD [ 7 Answers ]

I believe that when we re-run the program with the correct date and time, if the temp has to go up, the furnace runs until it gets the appropriate temp, then it turns off and when it does that, the thermostat also turns off going to the HOLD state.:confused:

Kenmore Electric Dryer Thermostat [ 1 Answers ]

I am replacing the thermostat on a Kenmore electric dryer. I need to know which terminal the red wire goes on. There are 3 terminals numbered 1, 2 and 3.

How to check Operating Thermostat on a Kenmore Dryer [ 1 Answers ]

Kenmore dryer not heating. My dryer has an operating thermostat that has 4 terminals on it. 2 connected to red wires on both ends and 2 on the top with purple wires. I checked the terminals with red wires for continuity and it looks good with zero reading. Do I test the top terminals as well...


View more questions Search