Ask Experts Questions for FREE Help !
Ask
    budkopp's Avatar
    budkopp Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Feb 24, 2008, 09:24 PM
    Kenmore Model 417 stacked washer/dryer agitator removal
    There's a sheet stuck under the agitator on this machine. I've removed the cap of the agitator by unscrewing it. There's a stud under it with a 5/8" hex bolt in a very tight space. Is there a special wrench to unscrew this? I have a 5/8" socket but I doubt if it will fit over the bolt because it is inset.
    esquire1's Avatar
    esquire1 Posts: 2,483, Reputation: 209
    Ultra Member
    		  
    #2

    Feb 24, 2008, 09:32 PM
    Are you sure it's 5/8? All I've ever seen were 7/16 and with an entention on it, easy to remove
    budkopp's Avatar
    budkopp Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Feb 24, 2008, 09:35 PM
    I measured it and it's 5/8", surrounded by a six-sided opening of 3/4", so there's very little space to fit a socket into.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Kenmore Front Load Washer Model 417.41042000 - No Motor Movement [ 1 Answers ]

I found a troubleshooting guide inside the cabinet that says, "...set timer to the start of the Regular wash cycle and pull the know out. If the motor does not rotate, check for a poor connection in the timer line switch or door lock switch. If good, and motor does not run go to step 3". ...

Kenmore 80754 Top Load Stacked Washer / Dryer [ 1 Answers ]

My washer drum is out out balance in all spin cycles. I used to repair the old dryers where all you need to do is replace solenoids, thermostats, htg. Coils, etc... so I am somewhat familiar w/appliance repair. What do I need to do to fix this at home?

Kenmore tumble washer model 417 [ 0 Answers ]

My washer will not drain after the rinse cycle:confused:

View more questions Search