Ask Experts Questions for FREE Help !
Ask
    Bio's Avatar
    Bio Posts: 4, Reputation: 2
    New Member
     
    #1

    Dec 30, 2007, 03:57 PM
    Kenmore gas dryer removal?
    I have a kenmore gas dryer that needs the motor replaced. Problem is that I'm not sure how to remove the blower blades that sit in front of the motor. The dryer model number is 110 70942990. I have the parts on order and would like to do the repair myself. Any help would be appreciated!

    Thanks!
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
     
    #2

    Dec 30, 2007, 04:31 PM
    Look at Welcome to the Parts Store for a parts diagram. It should help.
    biggsie's Avatar
    biggsie Posts: 1,267, Reputation: 125
    Ultra Member
     
    #3

    Dec 30, 2007, 05:45 PM
    Some blower fans are attached to the motor shaft with a set screw. Look for one around the circumference of the fans center ring. Some are attached with a "C" clip which should be plainly visible. Use a "C" clip removal tool, if you have one or a needle nose pliers. Others are a press on fit using a key way in a slot in the shaft of the motor. Fan than pulls off and new one pressed back on. Several different methods used. Not sure for the model you have but most are easy enough to figure out. May have to remove the entire motor assembly to access only the fan blades inside the blower cage.

    Appliance Parts from RepairClinic.com - Detailed Appliance Illustration
    Bio's Avatar
    Bio Posts: 4, Reputation: 2
    New Member
     
    #4

    Dec 31, 2007, 05:11 PM
    Parts are in and installed. To remove the blower blades one has to use a 1/2 inch drive ratchet and a 7/16 open end wrench on the motor shaft. The threads are left handed. After removing the blades there were only three 1/4 metal screws holding the blower housing in place.

    Hope this will be of some help to some.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Model # of Kenmore Elite Catalysts Washer set to Kenmore 110.60936990 dryer from 1999 [ 3 Answers ]

I am experiencing weird problems with my top of the line Kenmore Elite Catalysts washing machine. I bought the washer and dryer as a pair for about $1700 in 1999. The dryer model # is 110.60936990 but the sticker has worn off the washer so I do not know the model #. I think it could be...

Kenmore Stackable Dryer/Washer Dryer Squeaks [ 1 Answers ]

We have developed a squeak in the dryer. It does heat okay and clothes are tumbling well. I went online to get the schematics of the dryer drum, but would not know where to start as parts are numbered and not named. Help:confused:

Kenmore agitator removal [ 1 Answers ]

Hi Everyone says the same thing... remove the cap remove the sofner dispensor(if there), and then... presto there is the bolt, remove the bolt and slide agitator up and off. My problem is the bolt just seems to spin and spin and spin, if I hold the agitator, the bolt never comes off it just...

Kenmore Timer Knob Removal [ 1 Answers ]

I have to replace the water temperature switch on my Kenmore Washer but am unable to rempve the timer knobs. How is this done? The timer knob actually consists of two knobs with a clear plastic disc between them.


View more questions Search