Ask Experts Questions for FREE Help !
Ask
    mike222's Avatar
    mike222 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Aug 29, 2008, 09:43 AM
    Kenmore Elite Catalyst Top Load Washer TOUCH Panel dead
    Washer will not start, Touch Panel will not light, turn on. Did this once before and started to work a day later, now dead for 4 days. Acts like no power (yes working, changed plug).

    Any Ideas?
    glensb's Avatar
    glensb Posts: 1, Reputation: 1
    New Member
    		  
    #2

    Dec 5, 2008, 05:08 PM
    Try changing the touchpad assy. My Kenmore Elite Catalyst washer did same thing intermittently, Model # 11022054100. Changed out the control board did not help. I noticed some of the touchpads did not give correct resistance during ohm meter check. I was hesitant to spend the additional $200+ to verify it was the touchpad assy, but gave it a shot. Found the part online at repairclinic.com. About 10 minutes to install, my wife is happy not having to make more trips to the laundromat.

    RepairClinic.com - Appliance parts for 80 brands, shipped same day.
    mountain007's Avatar
    mountain007 Posts: 1, Reputation: 1
    New Member
    		  
    #3

    Dec 6, 2008, 06:10 AM

    I have a kenmore elite washer he t3 and it will get half way through the cycle and then its starts flashing SUD (and there is no extra suds in there) then it will flash f 02. Please help is there a way to
    Reset my controls or something.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Kenmore elite catalyst washer not spinning [ 1 Answers ]

Model number 11020072991 Ok, here's where I'm at. I believe it's the drive coupler? I've disconnected the control panel and fliped it back. I remove the brass colored springs holding on the cover and removed the cover after disconnecting the clamps and hoses needed. Now, I'm stuck and don't...

Kenmore Elite Catalyst TOP LOAD leaking [ 5 Answers ]

I just purchased a "used" washer & dryer and got them home and the washer leaks. Kenmore Elite Catalyst heavy duty, top load, king size capacity, ultra quiet, etc. Under the lid: SM 9710768-D. It fills just fine, washes fine, rinses fine but then after the rinse the water comes out the back...

Kenmore Elite Catalyst Washer [ 1 Answers ]

My Kenmore Elite Catalyst Washer with digital display was not spinning. I replaced the coupler, the old one was worn. The washer did spin however it made a whinning noise. I ran several loads and now it will not spin again. Any suggestions on what the problem may be? Thanks.

Kenmore Elite Catalyst Washer OL err Code [ 1 Answers ]

I have a Kenmore Elite Catalyst Washer that is reading the error code OL. I do not have model number. I bought the washer and dryer from a used vendor I have looked everywhere for the model #, I guess they might have scratched it off? If anyone has an error code list of this washer...

View more questions Search