Ask Experts Questions for FREE Help !
Ask
    homerepair's Avatar
    homerepair Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Mar 16, 2007, 04:20 AM
    Kenmore Dryer - Model 110.96281100
    I have a Kenmore dryer - model 110.96281100 which stops mid-cycle or won't start at all. Removing the timing unit revealed a bit of black dirt which I cleaned. It worked fine for about 2-3 days but then went back to same old status - sometimes starting, sometimes not. I'm trying to figure out if I need to replace the timer or the resistor. Any help out there would be appreciated.
    doug238's Avatar
    doug238 Posts: 1,560, Reputation: 62
    Ultra Member
    		  
    #2

    Mar 24, 2007, 10:33 PM
    KENMORE WASHER AND DRYER
    Epinions.com - Posts in Sears Kenmore Elite Dryer Won't Run If Start Button Released
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Kenmore Dryer Model 110.86873100 [ 1 Answers ]

Where is the heating element located on a Kenmore Dryer, Model #110.86873100?:)

Kenmore Dryer model 110.96272100 [ 5 Answers ]

Please help: My Kenmore dryer has been shutting itself off after a few minutes; before completing its cycle, it will restart when pushing the start button. But will shut off again after a few more minutes.

Kenmore Elite Dryer Model 110.63932102 will not heat [ 6 Answers ]

My dryer stopped heating although it runs. I confirmed I was getting 240volts at the source. I checked the continuity of the element, the thermal fuse and the thermostat and found that they were continuous. I have read that the thermistor might have something to do with it...

Kenmore Elite Model 110 [ 1 Answers ]

The washing machine is not spinning, so I am attempting to replace the coupler. I am able to partially remove the front console, but I can not remove the main knob. I found instructions that say to hold the dial and turn timer knob counter clockwise, but this is not working. This should be...

View more questions Search