Ask Experts Questions for FREE Help !
Ask
    smustian's Avatar
    smustian Posts: 2, Reputation: 1
    New Member
     
    #1

    Dec 25, 2009, 07:30 PM
    Kenmore Dishwasher Ultra Wash will not turn on
    I have a 5 year old Kenmore Ultra Wash Quiet Guard 4 dishwasher. During a run cycle, I heard a click and went to investigate. The entire control panel is dead, as in no lights anywhere. All wash arms spin freely. No idea where the power comes from so I decided to disconnect power wires to see if it would reset. Upon removing the electrical connection cover, I found the white wire connection charred (yellow twist connector). I will pull the unit out tomorrow to see if I see anything else and try to reset the motor if it has one. What could have caused the wires to fry?
    hkstroud's Avatar
    hkstroud Posts: 11,929, Reputation: 899
    Home Improvement & Construction Expert
     
    #2

    Dec 26, 2009, 05:13 AM

    A loose or poor connection can cause over heating at the connection point. Turn power off at breaker panel. Remake connection.
    There will not be a reset at the motor at the motor, it is only a water pump motor.
    smustian's Avatar
    smustian Posts: 2, Reputation: 1
    New Member
     
    #3

    Dec 26, 2009, 09:51 PM

    Thanks hk. This morning I cut back the burnt wires and reconnected them. Cycle picked up where it left off when I pushed "start". Maybe the wire connector loosened up over time. Who knows. All seems good now. Thanks again for the quick response.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Kenmore elite ultra wash dishwasher quiet guard 7 with the turbo wash. [ 1 Answers ]

I have a kenmore elite ultra wash dishwasher quiet guard 7 with the turbo wash. The middle spray arm has stopped spinning. I changed the feed tube going up to the arm, but to no avail. The feeder tube assemble didn't come with the Turbo section. I checked the water level and it seems adequate and I...

Kenmore Ultra Wash Dishwasher - flashing normal wash and Cancel lights? [ 1 Answers ]

Kenmore Ultra Wash Dishwasher - flashing normal wash and Cancel lights? Is there any easy fix to the flashing lights? I have the "normal wash" and "Cancel" lights flashing. The dishwasher does not work. Model: 665.1385

Kenmore ultra wash quiet guard deluxe dishwasher is stuck in wash cycle [ 2 Answers ]

I got a kenmore ultra wash quiet guard deluxe dishwasher for Christmas. My husband installed it and it seems like it is stuck in the wash cycle. It ran for an hour and a half and it never drained, so we finally shut it off. Any suggestions?

Kenmore Ultra Wash Dishwasher [ 0 Answers ]

I have a Kenmore Ultra Wash Quiet Guard 4 Dishwasher Model #665,17032 400, 2 1/2 years old. Of course the warranty has expired (about the same time the problems started) Sears repair man, has changed a fuse 3 times and advised to #1 not use the smart wash option, use the normal wash instead, #2,...

Kenmore Ultra Wash dishwasher [ 2 Answers ]

I am looking for a user manual or simply some explanation as to the various controls on the Kenmore Ultra Wash dishwasher. It is an older model #110753613 Serial number FFA0404041 I have done a lot of searching on the net and the only thing I can find is that Kenmore will give you the user...


View more questions Search