Ask Experts Questions for FREE Help !
Ask
    LooneyLouise's Avatar
    LooneyLouise Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Jul 24, 2007, 07:42 PM
    Kenmore Dishwasher
    Stock Number 16849
    Serial Number FE4711416
    Model Number 1684993

    Suddenly started leaking between the bottom of the dishwasher door and the top of the bottom faceplate. We moved into this house 7 months ago. No owners manual. This is not while the dishwasher is draining. It is just a few minutes after you start it up, as it is filling with water. It didn't just start leaking a little bit. When it started leaking, it really went full blown. Any suggestions as to what is causing this and how to fix it?
    esquire1's Avatar
    esquire1 Posts: 2,483, Reputation: 209
    Ultra Member
    		  
    #2

    Jul 25, 2007, 04:29 AM
    I would do a very close visual on this when it is pouring out. A leak that size should not be difficuilt to locate. You might also with washer not running put a flashlight inside pointing toward door and see if you can see anything. Maybe even some crud has gotten under door and not letting it seal properly. Good Luck
    LooneyLouise's Avatar
    LooneyLouise Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Jul 25, 2007, 11:40 AM
    Thank you for the suggestions. We'll try that.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Kenmore dishwasher [ 2 Answers ]

My dishwasher won't start any cycles. I have noticed that the start button which usually lights up a steady green light once the cycle is set to begin is flashing green 7 times and does not begin to start the cycle. Is there any way possible to reset the control panel? :confused:

Kenmore dishwasher [ 1 Answers ]

I've tried just about every detergent in my dishwasher and none of them will dissolve.

Kenmore Dishwasher [ 1 Answers ]

My dishwasher recently tripped my circuit breaker and my dishwasher was stuck in dry mode. I reset the circuit breaker and it kept getting stuck in the dry cycle. My spin device in the bottom of the dishwasher melted to the heating coil so I replaced the spinner. I then repaired the timing motor so...

Kenmore Dishwasher [ 1 Answers ]

Hello, I have an older model Kenmore dishwasher which is no longer washing the dishes clean. What is the most cost-effective method; to repair or replace? Please advise.

View more questions Search