 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Kenmore dehumidifier starts but then stops after a minute or 2 and won't continue, do
3 year old Kenmore 50 Pint Dehumidifier w/Electronic Touch Controls starts for 60 secs then quits and won't continue. It is clean, Is this a sensor assembly problem or main pwb/pcb assembly prob? Or something else. I have not repaired Dehumidifiers before.
|
||||
Check out some similar questions!
Hi: I have a 14 year old Kenmore top load washer. Today while doing a load, the washer filled as normal, but now the agitator starts for about 5 seconds then stops for about 4 minutes, this has been going on for about 2 hours now. Is the washer toast? Is it something that can be repaired? ...
Kenmore washer will start to wash then stop. Starts and stops frequently. Will not run through cycles without many stops an starts. Could it be the timer??
I have a Kenmore washer Model 110.92583100 serial CD2411995 it will start to spin at low speed for about 10 to 20 seconds, then it will stop. If I leave the switch on there will be a 3 or 4 minute delay and it will start again for the same amount of time. I put a new centrifugal switch in because...
My top loading Kenmore washer model 110.92588210, direct drive, runs for 10 seconds and stops for a minute then starts and stops for longer than one minute, this continues and the stop time gradually increases with every restart. No matter which cycle I choose. There is no problem filling with...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
