Ask Experts Questions for FREE Help !
Ask
    gusmeg1947's Avatar
    gusmeg1947 Posts: 1, Reputation: 1
    New Member
     
    #1

    Aug 28, 2014, 03:41 PM
    Kenmore 665-13893K801 dishwasher - cannot stop or start, lights do not respond to req
    Dishwasher just stopped working. Have attempted numerous 'resets' and it runs for a while, yet I still get no light nor response we pressing the start and stop finger pads.

    After a 'reset' all lights light up. At this point I am unable to stop or start. I can select a wash cycle, yet I cannot start it. If I close the door it will run after a short delay
    drtom4444's Avatar
    drtom4444 Posts: 3,282, Reputation: 145
    Ultra Member
     
    #2

    Aug 29, 2014, 12:57 PM
    You could have something sticking, like the float level switch or something like that. Make sure to check your filter and take the spray arms off and see if they have trash in them, then check the pump clean-out.
    Another problem that is very common with that dishwasher is that the control panel where the buttons are located gets dirty from moisture getting into it. To repair it you have to remove the panel and peel off the rubber front and clean both surfaces with dishwashing soap and water with an old soft toothbrush. Then wash off with water and then alcohol (95% isopropyl) and let dry in sun or a warm, dry place. Check for corroded or loose connections which also may be causing your problem. You can find these all over the machine, but more than likely around sensors and safeties, like the safety switch on the door latch, which is a microswitch. Look for corrosion near solder joints because in a moist environment the tin in the new lead-free solders corrodes more easily than the old lead-tin solders, plus manufacturers often do not heat the solder hot enough to make a lasting connection. You will have to go through it with a “fine-tooth comb” before you find the bad connection or safety.
    Here are some manuals: https://dl.dropboxusercontent.com/u/...e%20Manual.pdf
    https://dl.dropboxusercontent.com/u/...Electronic.pdf
    https://dl.dropboxusercontent.com/u/...Dishwasher.pdf
    https://dl.dropboxusercontent.com/u/...ishwashers.zip

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Blinking lights on kenmore 665 ultra wash dishwasher [ 0 Answers ]

Tried all sequences none have worked very fustrated kenmore ultra wash 665 1671

Sears kenmore dishwasher 665.1603 won't start no lights visible [ 0 Answers ]

Sears kenmore dishwasher 665.1603 won't start

Flashing lights on kenmore dishwasher model 665.16632 [ 1 Answers ]

The lights on my Kenmore model 665.16632 dishwasher started flashing half way into the wash cycle and would not restart. By chance I pressed and held Cancel/Drain for a few seconds and the lights stopped flashing. We started another wash cycle hours later and it worked. I later found that the...

Kenmore Ultra Dishwasher 665.15772990 blinking lights? [ 1 Answers ]

I was running a load of dishes when I noticed the dishwasher had stopped working and the lights were flashing. When you push 'any' button - it flashes. I've tried researching reset codes but can't find one for this dishwasher. I've tried pushing normal wash and water heat as well as normal wash...


View more questions Search