Ask Experts Questions for FREE Help !
Ask
    Randyrtx's Avatar
    Randyrtx Posts: 2, Reputation: 1
    New Member
     
    #1

    Aug 3, 2012, 04:52 PM
    Kenmore 11024962300 spin cycle stops and starts
    When the spin cycle starts, within a few moments it stops. I've verified that the thermal cutoff switch on the motor is engaging (open circuit). After it cools and disengages, it will attempt to spin again and repeat the cycle. I'm not certain but I don't think it is reaching full spin speed.

    I replaced the clutch band and brake cam, and also replaced the motor, and it still does the same.

    The wash cycle runs normally, and I don't notice any strange noises or anything. Also, the underside and floor is clean, no oil leaks.
    Randyrtx's Avatar
    Randyrtx Posts: 2, Reputation: 1
    New Member
     
    #2

    Aug 3, 2012, 10:09 PM
    Answering my own question, maybe it will help someone with a similar problem.

    I disassembled the timer module and found that one set of contacts had completely fused together. I was able to separate them and clean them up enough to try it out, and that fixed it.

    Good enough for a quick fix, but I still plan to replace the timer.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Kenmore dryer starts but stops mid cycle [ 0 Answers ]

I have a kenmore dryer about 12 years old. It has been in storage for about 4 of those years. It is a model 110 66902691. I hooked it up and it runs for about 10 minutes and stops and will not start again for about another 10 minutes. Sometimes it just makes a loud noise like the motor is trying to...

AC starts a cycle stops and loud noise starts from inside Air Handler. [ 1 Answers ]

The central a/c unit worked fine all day and in the evening started a new cycle stopped after about 30 seconds and started making a loud noise inside the air handler for around 90 seconds and tried to start a new cycle without success. I turned the unit off overnight and back on the following...

Washer machine will not complete entire cycle. It gets to the spin cycle, and stops. [ 1 Answers ]

I have a GE washer, (about 5 years old). The washer goes through the wash and rinse cycles fine. When it gets to the spin cycle, it stops. I can override and manually place the machine on spin. How can I fix this problem so the cycle runs through completely. Thank You

Kenmore washer starts to spin then stops [ 1 Answers ]

I have a Kenmore washer Model 110.92583100 serial CD2411995 it will start to spin at low speed for about 10 to 20 seconds, then it will stop. If I leave the switch on there will be a 3 or 4 minute delay and it will start again for the same amount of time. I put a new centrifugal switch in because...


View more questions Search