Ask Experts Questions for FREE Help !
Ask
    jomomma123's Avatar
    jomomma123 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jun 13, 2009, 12:46 PM
    Kenmore 106.56659500 freezer covered with snow and refrigerator vents frozen solid
    I purchased my refrigerator in 2005, bottom crisper drawer always iced things over so I never used it. But now inside of freezer covered in snow.. Refrigerator vents all of them are frozen underneath solid... Milk started going bad sooner... fridge not too cool. After some research... though it might be the bimetal defrost thermostat... so I am defrosting my fridge now.. big question...

    HOW DO I TEST THE BIMETAL DEFROST THERMOSTAT?? WHERE DO I PLACE THE OHM METER...PLUS MY EXPERIENCE WITH THE OHM METER IS LIMITED MY HUBBY KNOWS A LITTLE MORE THAN I DO BUT THAT ISN'T SAYING MUCH?

    I just don't want to have to defrost it again... when I could just order this part and replace..

    SOMEONE HELP! :eek:
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Jun 13, 2009, 03:17 PM
    Whenever there is a defrost problem with a ice box I always just replace at least the defrost termination thermostat and the timer. The defrost thermostat is difficult to test since many refrigerators use different fixed temperature settings and unless you have a very accurate temperature test device the test will not provide proper results. Now you can take the defrost thermostat out of the unit and place the element only in a glass of ice water. When the element is cold it should have continunity between the two wires. As I said it is not a accurate way to test this device. The defrost heater,timer.or a combination of any two could be causing the problem.
    drtom4444's Avatar
    drtom4444 Posts: 3,282, Reputation: 145
    Ultra Member
     
    #3

    Mar 22, 2011, 03:21 PM
    You need continuity across the defrost thermostat at 32 degrees, meter should read zero of close to that. You also test defrost heater which should read according to the wattage rated on the name plate. If the defrost heater reads 2 ohms take 120 volts and divide by 2 to get a 60 watt heater, for example. The way to test the system is to find the defrost timer which is a black or white box with a timer motor and a one-way screw slot on the front. Turn screw slot and you will hear clicks and then the refrigerator and fan will stop. When it does this stop turning it and watch it. If it heats up and will not start refrigerator back to cooling cycle you have a bad motor on timer (a common problem). If the refrigerator stops and ice stays in freezer and then refrigerator starts back running you have either a bad defrost heater or defrost terminator thermostat. You can usually spot a bad defrost heater by looking at it because it will be burned in two pieces. Often people will replace both heater and terminator at same time to prevent a call-back when the other one fails that was not replaced. You also have a fan thermostat which keeps fan off until temp on coil reaches 20 degrees. Sometimes the two are combined and you have three wires on round t-stat.DrTom4444

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

New kenmore refrigerator accumulating ice in freezer [ 11 Answers ]

Hi! I purchased a new top mount frost-free Kenmore refrigerator (very basic model - no ice maker or water dispenser) @ 1 month ago. We had problems with ice droplets accumulating on the ceiling and back of the freezer wall. This appeared to be because there was a problem with the seal on the...

Kenmore side by side -refrigerator warm ,frezer icing near vents [ 2 Answers ]

Ice maker in door barely making ice and forming icicles on door and near vents in freezer. The refrigerator is warm and cold air from freezer is not flowing into refrigerator. Ice is forming on door of freezer and near the vents .

Amana bottom-freezer refrigerator: fridge not cold, freezer is frosty! [ 1 Answers ]

Hi everyone! I have a slightly over a year old Amana bottom-freezer refrigerator (model #: ABR1922FES). Yesterday, I noticed that the fridge wasn't as cold as it should be, so I turned the temp control cooler, and then, as per the owner's manual, waited 24 hours for it to kick in. It didn't....

Roofers covered 1 of 3 roof vents for sewer [ 4 Answers ]

Our house is an older house, I was putting in a ceiling fan and had to remove some drywall over a closet. I noticed that a vent pipe (for kitchen) had fallen on the top of the closet. The pipe had a elbow in it hat had rusted (bad salt air problem here), when they were putting the new roof on...


View more questions Search