Ask Experts Questions for FREE Help !
Ask
    bigrob's Avatar
    bigrob Posts: 1, Reputation: 1
    New Member
     
    #1

    Mar 19, 2012, 08:09 PM
    I just installed a richmond 40 gal gas water heater and the pilot won't light
    I followed the instructions pushed pilot button down and pudhed igniter several times but it won't take off, I've done this so many times the igniter doesn't even flash any more
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
     
    #2

    Mar 19, 2012, 08:26 PM
    The first time you light a new water heater or gas anything it can take a few minutes to purge the supply line of air. Make sure your control knob is pointing at PILOT, push it in and hold for a full 30 seconds and then spark the ignotor. Which model Richmond is this?
    drtom4444's Avatar
    drtom4444 Posts: 3,282, Reputation: 145
    Ultra Member
     
    #3

    Mar 19, 2012, 09:14 PM
    The flame has to just be on the tip of the thermocouple on the 1/2"-3/8" part. You may have ruined it.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Water heater won't light, pilot is on, so is it the gas valve? [ 4 Answers ]

I have a maybe 9 year old AO Smith water heater, model number FGR 50 242. The pilot is burning, but the burner will not light. I cranked the temp up all the way and nothing. I scrubbed the thermocouple (ie the device that sticks into the pilot light) lightly with a wire brush (just for fun I guess,...

Does putting gas hot water heater dial on PILOT put pilot light out? [ 5 Answers ]

My gas hot water heater dial has OFF to the left, PILOT in the middle and ON to the right. If we are going away and want to not have the water heated can we just turn the dial to PILOT and the flame will stay lit but just won't heat the water or does the flame go out completely and then PILOT would...

Gas water heater pilot light won't stay lit [ 2 Answers ]

The pilot light on our State Censible gas water heater will not stay lit... it is not the thermacouple and it is protected from drafts. We light it daily... we get enough hot water for about 2 showers and a load of dishes. What could be causing this problem?

Cannot relight gas water heater pilot light [ 2 Answers ]

After I light it, my gas water heater pilot light always goes out when I release the pilot light knob. This occurs regardless of how long I have been depressing the knob (usually several minutes) to keep the pilot light going after I have ignited it.

Gas Water Heater burner/pilot light . [ 1 Answers ]

Hey there, It has been a wild week. I had to travel 2 hours to a hospital because they thought my grandfather had an anyerism. Luckily he is still in the hospital but OK. But when I got home I had no hot water. Check and pilot light was out. Relit pilot OK. Turned thermostat knob up, burner...


View more questions Search