Ask Experts Questions for FREE Help !
Ask
    schmidtyj65's Avatar
    schmidtyj65 Posts: 1, Reputation: 1
    New Member
     
    #1

    Mar 3, 2012, 10:48 AM
    How do I test the high temperature limit switch above the heat exchanger?
    The induced fan comes on then the burner comes on for about 90 seconds then shuts off without the main blower coming on. The induced fan continues to run then the burner comes on again for 90 seconds of so then off again with induced fan still running. Finally 15 minuites later the blower starts while the burner is off. After a couple minuites of this the burners does come on for a short peroid of time and off then back on until finally the thermostat is satiefied and the unit shuts down.

Check out some similar questions!

Inadequate Flow to prevent heat exchanger from tripping limit switch. How fix? [ 15 Answers ]

This is a long post. I believe giving all of the relevant information will better enable good responses. My 2800 ft^2 house in Massachusetts built in 97 uses a Bryant 383KAV 80%, 154KBTU/hr input, 2 zone (pressure side only dampered)gas furnace, model #383KAV060155. I have come to realize...

Temperature limit switch [ 3 Answers ]

I have a Trane XR80 furnace, with a self-check flash code system (flashing red light). The furnace has been blowing cold air when turned on, and not heating up. The red light flashes 4 times, indicating that we have an "open Temperature Limit circuit". I believe that this means that our...

Troubleshooting 4 flashing lights - open high temperature limit switch [ 7 Answers ]

Thanks for your input. I finally was able to reverse the wiring and got it squared away. While I was in the attic I thought I would replace the motor which drives the fly wheel. I thought I was a hero till I put everything together and discover 4 flashing lights. The lights indicate "open high...

Trane xe 80 open high temperature limit switch [ 1 Answers ]

Furnace is about 13 years old... we just replaced the ignighter in it last night because it was running through all the steps to run except ignighting. It fired right up and ran for about 7-8 hours... now it won't ignite at all (it is running through all the steps it needs to except for...

What are the temperature settings for a fan limit switch [ 2 Answers ]

I have a 30+ year old forced air furnace. Currently, when the thermostat is turned up to call for more heat, the burners ignite normally. When the heat exchanger-HE- gets to temperature (which seems to take a long time) the fan switches on normally. HERE'S WHRE THE PROBLEM STARTS The fan...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.