Check out some similar questions!
Wiring changes: Johnson Controls G600AX-1 With Honeywell S8610U Gas Ignition Control
[ 7 Answers ]
This is my very first post so... Hello everyone. and here is my question: I am replacing a Johnson Controls Pilot Gas Ignition control unit with a Honeywell 8610U and I am a little confused on how to connect all the wires. The wiring on the Johnson Controls unit is as follows: Main Valve...
Johnson control ignition module g600ax-3
[ 1 Answers ]
I have a Lennox furnace with a Johnston Control ignition control G600ax-3 which I am unable to locate to replace. I ordered a universal White Roberts 50D50-843. The G600ax-3 has a spark igniter connection similar to a spark plug connection and the WR is a spade connector, do I have to replace the...
Honeywell g600ax-1 no gas thro to system
[ 1 Answers ]
I'm not getting any gas to the line.. there is gas going into it but when I turn it on no gas goes to the ignition every once in a blue moon it will light then shut off like 1 -2 min latter I have no clue what to do I think it is the values that sitt right under I think there are not lifting or...
S8610U Universal intermittent pilot gas ignition control.
[ 2 Answers ]
I wire the module up correctly and have 24V to module but no spark or led fault lights. The exhaust fan starts up and ignition sequence starts but no spark. Suggestions or exsperience with this module. Thks Mike
Traying to replace a G775 with S8610U IGNITION control
[ 1 Answers ]
Having hard time wiring the replacment control Gas valve won't open flashing light indicat low secondary voltage . Every thing is done as per instruction View more questions Search
Add your answer here.
|