Ask Experts Questions for FREE Help !
Ask
    TraceySmith's Avatar
    TraceySmith Posts: 1, Reputation: 1
    New Member
     
    #1

    Feb 4, 2011, 10:16 AM
    I have a GE sensor dry model DBVH 512 GFOWW that squeaks.
    The dryer squeaks when it runs. When I manually turn the drum it squeaks less. There were greasy spots on a few clothes a while back, but it may have been from a new detergent. At first the squeak was only with heavy loads like jeans. Now it is all the time. Can I buy a part to fix? Would this be difficult for a one woman repair? Is there a way to tell what problem is or would I likely be fixing many things? Apx how much would it cost to repair on average if it is most likely issue?

    Thank you for your help :)

    I just found a small piece of plastic (similar to a plastic locking tie) sticking out of the upper inside of dryer towards the front. I tried to take a picture. I don't know if this helps or if I should upload it.

Check out some similar questions!

MAP sensor;Mass Airflow sensor;Volume Air sensor-All Same? [ 8 Answers ]

97 Nissan Pickup - 160,000 miles - KA24E engine -Check engine Soon Light Code reader says volume air sensor. Is this the same as a mass airflow sensor or the MAP sensor? Where is this sensor located, in the throttle body injection? Just threw a new O2 (Bosch)sensor on it, I lost that bet.. it...

Rheem Criterian Model A548M168-6R air conditioner blower cage squeaks [ 0 Answers ]

Rheem Criterian Model A548M168-6R air conditioner/heater blower cage squeaks. How can I fix it or must I get a repair tech to replace the motor.

Kenmore gas dryer Model 110 72722100 squeaks [ 1 Answers ]

Please tell me how I can stop my Kenmore gas dryer, model no. 110 72722100 from squeaking.

Kenmore elite dryer model #11063042100 that won't dry [ 2 Answers ]

I have a kenmore elite dryer model #11063042100 that won't dry. It comes on but it will not heat. I am also trying to find the schematics to the dryer.

Location of the flamer sensor in a Bryant Model 383K Furnace [ 3 Answers ]

Where is the exact location of the flamer sensor in a Bryant Model 383K Furnace? Is there a better diagram than I currently have in my user's manual? It is really for the installer. I know that I need to sand down/ steel wool the flame sensor, but can't remember the location. Thanks in...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.