Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Flash codes for Goodman GMP 100-3
[ 2 Answers ]
Anyone know how to interpret the led codes on this furnace?
Goodman GMP-100
[ 1 Answers ]
I have a Goodman GMP-100, purchased in 1996. Never a problem over the years but last year I had to replace the flame sensor. A $5.00 part, NO PROBLEM! Over the last couple months I notice when the thermostat (digital/programmable type) was in the OFF position, the exhaust fan would come on, then...
Are 22 coil GMP 100-4 furnace?
[ 4 Answers ]
I have an older system GMP100-4 serial # 9508802550. The repair man says I need new R 22 evaporator coils. However he states nobody makes them anymore and instead I need to buy a new system that would cost me $4500. Does anybody know where I might be able to get a hold of these? Thank you in...
I have a GMP 100-3 furnace and the circuit board indicates main limit switch.
[ 1 Answers ]
I have tried to jump the temperature limit switches and still nothing. The blower runs constantly and exhaust fan runs constantly. Any suggestions?
Blower motor wiring on a Goodman GMP
[ 2 Answers ]
I have a Goodman GMP forced air furnace running on natural gas. It is about 5 - 6 years old. It recently went out. The draft inducer would come on and the igniter would glow but then it would shut down without opening the gas valve. I checked and found that the board was never sending a... View more questions Search
|