Ask Experts Questions for FREE Help !
Ask
    J Fritz's Avatar
    J Fritz Posts: 3, Reputation: 1
    New Member
     
    #1

    Jan 2, 2007, 08:22 PM
    Fsp washer motor bearing repacement?
    I have FSP 357822 with bad lower bearing. Can the motor be split, the bearing replaced, and "re-glued"? I have done bolted together motors before, but never an apparently glued one.



    What can be used as glue in this case.

    Thanks in advance!
    CVDan's Avatar
    CVDan Posts: 1, Reputation: 1
    New Member
     
    #2

    May 2, 2008, 11:41 AM
    I'm working on an old dog just like yours. Did you solve the problem, and if so, how?

    Dan

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Load bearing wall [ 1 Answers ]

I have a 2 floor house that the 2nd flr is sagging. I have opened the ceiling under the sag and there's 3 2x8 nailed together as a header.my question the 2x8 header is appx 13 feet long is this to long for this size header or do I have another problem?

Load bearing walls [ 1 Answers ]

When replacing a load bearing wall what size lumber do I need to support a second story floor when the opening is 16ft. This wall is in the center of the house which is 24ft wide

Whirlpool Gold washer motor problems [ 1 Answers ]

I have a Whirlpool washer GSX9885JQ0 that burnt the motor and cap too. Is this a common problem. Is there a way to check the control board to see if that was the problem or is it one of those things that I need to replace the motor and if that burns up then next time I should replace the board...


View more questions Search