I have a kenmore elite dryer model #11070972990 i push the start button it makes a noise like it is going to start but doesn't then the noise stops and you push the button and you might just hear a clicking noise and nothing happens. When i go later to try it i push the button and it starts up. I have it on 60 minutes and when i go back to check on it it stopped on 40 minutes. It dryes for 20 minutes. The dryer was hot and the clothes dried a little. I then try to start it again and it is dead. Sometimes it will start and other times it won't. I am in desperate need of the correct part to have my brother fix the dryer. Please write back as soon as possible so that i can order the part from you and fix my dryer.thank you very much. Edith

You have to do a little research here.

To check what is going on in your dryer :

Remove the rear panel, and have a look as to what is going on.
Check the drive belt : is it frayed?
Is the drum running against something?
Does anything look lose or broken?

Please be careful : do not touch anything while the dryer is connected to the power.

If you can not find anything, remove the power - take the power cable out of the socket and put it on to the ground.
Note down how the belt is connecting the drum and motor.
Remove the belt (by taking away the tension from the belt this is easy).
Spin the (empty) drum a couple of times by hand, as fast as possible. Is it running freely?
Spin the motor a couple of times by hand, as fast as possible. Is it running freely?

This procedure will allow you to research what is the problem in your machine.
If everything seems fine your problem may be related to either the start capacitor of the motor having a resistance leak, or the thermostat cutting out.

The capacitor is almost always located in a rounded-off flat metal container 1' long mounted against the dryer frame or one of the walls. The value (on the housing printed in " uF ") and the numbers of connected wires are important.
If you remove the capacitor (note down how it is wired) you can take it with you to a service shop to have it checked and if needed replaced.
The thermostat is always mounted near or against the heating element. To check the thermostat you need a Volt or Multi meter, and the knowledge how to operate one.

Of course you can also come back to the board and discuss your findings!

Success !

:)