Ask Experts Questions for FREE Help !
Ask
    Mad Dan Morgan's Avatar
    Mad Dan Morgan Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Sep 5, 2008, 07:43 PM
    Dryer turns then it stops I turn the barrel it turns .
    Ok I have a Fisher and paykel model no. ED56AU when starting it sometimes I need to turn the barrel a few times to get it going or run it empty first for a while to make it work and even then I still have to turn the... thing a few times. It heats it drys but its getting worse lately
    jen_peters23's Avatar
    jen_peters23 Posts: 2, Reputation: 1
    New Member
    		  
    #2

    Sep 5, 2008, 08:06 PM
    If it has a transmission that sounds like it is going out or the motor because I had a washer that it would rotate till I put water and clothes in it and then it would just set there and shut itself off so they told me a new washer would be just as expensive as a new one so I just bought a new one and junked the old one but that sounds like the problem
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
    		  
    #3

    Sep 5, 2008, 08:18 PM
    If it's a capacitor start motor, then likely the starting cap went bad. This is usually a cylinder sitting on top of the motor but can be separate.

    Probably not likely that it has a centrifugal switch which is another way to start induction motors.

    The motor will usually include both items and is an integral part of the latter.
    Dman6966's Avatar
    Dman6966 Posts: 1, Reputation: 1
    New Member
    		  
    #4

    Dec 31, 2011, 09:45 AM
    You will have to open the back of the dryer. But it could be the drive belt and belt tensioner. I replaced the tub rollers and belt and hardware on a dryer brother in law was throwing away and I used it 5 more years with out a problem.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Starter turns but will not turn motor [ 1 Answers ]

I have a mtd 12.5 hp riding mower... I have done all tests on switch solenoid and by passed these and the starter mower will take off but when it engages to flywheel it seems to stop turning... the flywheel is not hard to turn therefore I'm thinking it still might be starter... the starter turns...

Single 20amp circuit turns off 10 min turns back on [ 2 Answers ]

I have a problem with a single 20Amp circuit, there are two small rooms with receptacles and lights attached to this circuit. (Home built in 1976). The power goes out completely and the 20Amp breaker does not trip or get hot, there is not any power across the breaker and then approximately 10min...

Light turns on & Fan turns off automatically when a remot is installed [ 2 Answers ]

I bought a Hunter remote separately and installed to my ceiling fan. Everything works good except the following problem. I turn on the fan & turn off the light before I go to sleep and in the middle of night the light goes on and fan turns off. This happens a few times until morning when I turn...

Fan will not turn off after Furnace turns off [ 1 Answers ]

The fan or hair handler on my home furnace will not turn off after the furnace has shut off?

View more questions Search