Ask Experts Questions for FREE Help !
Ask
    jim1970's Avatar
    jim1970 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 15, 2012, 06:50 PM
    Draining problem
    I have a kenmore elite he 3t frontloading washer which during the spin cycle has a clog somewhere within the machine as I have unhooked the hose in the back & flushed thoroughly. I see no access inside the machine to check for a clog or where a filter would be located. I appreciate any help given thank you
    outzie's Avatar
    outzie Posts: 4, Reputation: 1
    New Member
    		  
    #2

    Nov 16, 2012, 10:01 AM
    Are any codes flashing in the display? This can help determine the problem greatly. This usually would cause f02 to flash in the display. Small items can slip through and lodge in the pump especially baby socks, footies, knee high hose etc. If those items can get into the pump they can lodge anywhere. This will cause the machine not to drain or spin. If you think this is the problem you can check the pump/filter using the document instructions below. Be sure to unplug the machine and have plenty of towels on hand as this could be a bit of a wet mess. Good Luck.
    Attached Images
  1. File Type: pdf kenmore he 3t.pdf (234.1 KB, 129 views)
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Problem with toilet draining into tub [ 1 Answers ]

Wwhen I flush the toilet it backs up into tub with waste. Can I snakt the toilet and maybe that will clear it up?

Gurgling sound deep in pipes, but no draining problem? [ 1 Answers ]

I recently had a new bathroom sink installed (I live in a fourplex). Right before that (one and a half weeks ago) RotoRooter was also out and snaked my main drain and the outside sewer line and cleared some tree roots. Ever since RotoRooter and the remodel, I have noticed an occasional gurgling...

Bath tub draining problem [ 2 Answers ]

Hi! I have a bath tub water draining problem and now it even worst, for it need 30 minutes to get all water away, Since than I try to use lots of liquid plumr on it. But it helps not long. I think it's pipe line must have lots dirt. So I purchase a snack and try to only the bolt under bath. But...

Washer machine draining problem back-up [ 2 Answers ]

Washer mach. Backs-up when draining. Drain pipe is clean

A very draining problem! [ 2 Answers ]

Hi, We just moved into our new double-wide manufactured home which is 5ft off the slab. My husband had to add the supplied piping for all water and sewer lines which was no big deal. The problem is... our tub takes FOREVER to drain! Someone came out and checked the P traps which they said was...

View more questions Search