Ask Experts Questions for FREE Help !
Ask
    gangelozzi's Avatar
    gangelozzi Posts: 1, Reputation: 1
    New Member
     
    #1

    Mar 8, 2009, 03:24 PM
    Dishwasher fills up then stops
    I have a ge triton xl that will fill up then stop any idea's
    twinkiedooter's Avatar
    twinkiedooter Posts: 12,172, Reputation: 1054
    Uber Member
     
    #2

    Mar 8, 2009, 03:35 PM

    There could be a clog in the bottom where the screen is. This is a safety mechanism keeping the dishwasher from running and the motor from burning out. I have addressed this problem several times here on this site. To unclog the machine you have to remove the screen at the bottom of the tub. Then carefully reach your fingers into the tube and remove any and all large debris that are present. You may also have to clean out the sprayer arms little jet openings as well. You will probably have to clean out the bottom part several times and use a plunger as well depending on how clogged the machine is. Carefully put the screen back on and turn the machine on to see if that did the trick. Also if it does start up, be sure to run several empty loads through all the cycles to get any more debris out. You may have to remove the screen and remove more debris after each run through depending on the age of the machine and how much crud is in there. It's very surpsising what little bits of plastic and food can do to a dishwasher.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Dishwasher fills up with water [ 6 Answers ]

Whirlpool GU1500XTLQ0 The bottom of the dishwasher fills up with water when it sits. Seems to only take a couple of hours for the water to fill up enough that it will leak out the door if the door is open. Pressing the CANCEL button will drain the water. But it will fill up again in a couple of...

Dishwasher fills up with water when sink is running [ 1 Answers ]

Our dishwasher works and drains fine when it's running a cycle. When it is off, however, and the sink faucet is on and running water, the dishwasher fills up . It seems as if the sink is draining at least partially into the dishwasher. Any ideas? :confused: KLT

Kenmore Washer Fills, Agitator Starts and Stops [ 2 Answers ]

Hi: I have a 14 year old Kenmore top load washer. Today while doing a load, the washer filled as normal, but now the agitator starts for about 5 seconds then stops for about 4 minutes, this has been going on for about 2 hours now. Is the washer toast? Is it something that can be repaired? ...

Dishwasher fills with water but does not wash [ 2 Answers ]

I have an old ge dishwasher, a pot scrubber. When I turn it on the water goes in it but nothing else happens. The water spraying thingy does not turn, but it continues to go through the entire cycle including the drying cycle, but all the water is still in the bottom of the dryer. What could be...


View more questions Search