Ask Experts Questions for FREE Help !
Ask
    mfe1896's Avatar
    mfe1896 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Feb 18, 2012, 04:03 PM
    Amana # le8107w2 timer
    Thanks drtom4444 for your quick response but I have one more question where are the sensors for that kind of dryer? Just got home took dryer apart almost finish cleaning with soap an water just can't find sensors so I can clean it too.again thanks for you all you help...
    drtom4444's Avatar
    drtom4444 Posts: 3,282, Reputation: 145
    Ultra Member
    		  
    #2

    Feb 19, 2012, 07:30 AM
    The sensors are all along the duct work where you have air flow. Most of the time they are oval with a round center where two wires are attached. Some of these are safeties. The only way to know what they are is to look at the numbers stamped on them. The highest numbers are safeties, like 200 or 220, then sensors will be marked at 180, 160, etc. As long as they are all cleaned along with duct work you should be okay. Was there a lot of dirt in the ducts? Be sure to be thorough.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Amana # le8107w2 timer [ 1 Answers ]

Hello my dryer will not advance when its set on the auto dry (wrinkle free side) on my timer... it will dry my clothes great but it want advance on my timer I tried it with door open an close put it on auto timer with my ear close to the timer still no clicking clock timer noise... check breaker...

Intermatic t103 timer 30 amp breaker 10/2 romex 120 v to timer want two timed 120v [ 7 Answers ]

I have a intermatic t103 timer I have a 30 amp breaker I have 10/2 romex from the breaker to the timer the timer says it is double pole single throw I want two 120 volt wired outlets from this timer it says it has a 120 volt clock it has one terminal that has the letter a on it and a white wire...

Maytag dryer atlandtis.timer will not advance. Heat works.replaced timer still will [ 1 Answers ]

I have a maytag atlantis. The timer will not advance. The heat works.I replaced the timer still will not move.

Amana Dryer Timer does not move & stop in Auto/delecate Mode [ 4 Answers ]

:confused:My Amana gas dryer ALG 443 RAW works fine in all modes but Timer does not move & does not stop in Auto/ Permanent press mode. Dryer runs for ever.But it stops in the timed dry. The timer is fairly new. I checked the cycling thermostat's 3 terminals for continuity as well as Bias heater...

View more questions Search