Ask Experts Questions for FREE Help !
Ask
    Pawson's Avatar
    Pawson Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Feb 20, 2014, 11:58 AM
    Agitator problem
    I have a Kenmore stacked washer/dryer, 417.94812301
    The agitator wasn't working. I took off the dispenser and the cap below it. Now the bolt is stuck.
    A guy told me that sometimes on washers, the bolts go in the opposite direction than you would think.
    I tried going both ways. When I go clockwise, I can't budge it. (I tried some WD-40 on it.) When I go counter clockwise, the whole tub goes around.
    Which way does the screw go and is there a way to keep the tub and agitator from going around when I am working on it? Thanks - Julie


    [email protected]
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Washing machine agitator problem [ 1 Answers ]

I have an older-model "Roper by Kenmore" top-loading washing machine, bought used, a few years ago. It works fine! Washes, spins, drains, etc. But the agitator has developed a problem and I can't figure out how to find out what's gone wrong--let alone how to fix it. The bottom half of the...

Agitator problem [ 3 Answers ]

I have a Kenmore laundry center Model MLXE42RED, it is old I know but all the main parts work great. I have had it apart a few times and manage to fix it myself, after having it apart the last time to change the bearings in the washer motor ( which they say you can't do and have to buy a new one)...

Agitator [ 1 Answers ]

Is the tub suppose to move while the agitator is working? It is a kenmore 110.92281100. The agitator works fine but the drum just sits there until the next cycle which it starts spinning and draining. Just wondering if I might have a problem.

Timer/Agitator problem with Maytag A613 [ 1 Answers ]

Here are my notes thus far: PROBLEMS: -washer will fill with water -agitator will not engage -timer will go through the complete wash cycle but will not rinse or spin cycle POSSIBLE CAUSES with NOTES ON INSPECTION - bad belt *checked and operational -bad drain pump * checked and all...

View more questions Search