View Full Version : He3 Kenmore Elite Dryer Won't run selected cycle.
artistb
Apr 15, 2007, 12:48 PM
I have a HE3 Kenmore Dryer Elite.
All lights work and you can push selected functions. When you push the start button it sounds like it just clicks off. Won't start the cycle... is this a sensor relay switch problem. The venting and lint is clear.
Thanks
artistb
Apr 16, 2007, 07:50 PM
Well I guess I will answer my own problem here.
After talking to one of my appliance repair friends... I followed up on his instructions.. to find my thermal fuse and thermister. Did a check on my fuse and that was the problem. So I replaced the fuse and thermister control... all is working fine. Cheap repair I must say could have been worse.
mdsmshea
May 16, 2007, 02:20 PM
Well I guess I will answer my own problem here.
After talking to one of my appliance repair friends...I followed up on his instructions..to find my thermal fuse and thermister. Did a check on my fuse and that was the problem. So I replaced the fuse and thermister control.....all is working fine. Cheap repair I must say could have been worse.
My he3 is doing the same thing was it the fuse or the thermister and where are these parts located?
Thank You,
Michael
mdsmshea
May 16, 2007, 02:36 PM
I have a HE3 Kenmore Dryer Elite.
All lights work and you can push selected functions. When you push the start button it sounds like it just clicks off. Won't start the cycle....is this a sensor relay switch problem. The venting and lint is clear.
Thanks
Can you help me find fuse and thermister on my he3 i have the same problem
Thanks michael
shutcherson
May 31, 2007, 02:18 PM
I have a HE3 Kenmore Dryer Elite.
All lights work and you can push selected functions. When you push the start button it sounds like it just clicks off. Won't start the cycle....is this a sensor relay switch problem. The venting and lint is clear.
Thanks
Shutch