What buttons do I use to reset my keno more ultra wash quiet guard deluxe dishwasher?

Have you tried the maintenance manual?

Look here: https://dl.dropboxusercontent.com/u/8010163/Kenmore_Ultrawash_Dishwasher.pdf
https://dl.dropboxusercontent.com/u/8010163/Kenmore_Resetting%20fault%20codes.docx

Try Heated Dry, Normal, Heated Dry, Normal, Heated Dry, Normal. Run. All the lights should light up. Let run a minute then press Cancel/Drain and let it drain and shut off. It resets most Kenmores.

Look at these: https://dl.dropboxusercontent.com/u/8010163/Kenmore_Ultrawash_Dishwasher.pdf
https://dl.dropboxusercontent.com/u/8010163/Whirlpool_Kenmore%20Dishwashers.zip
Press: Heated Dry, Hi Temp Wash, Heated Dry, Hi Temp Wash, close the door, Start, Open the door, Cancel 2x.
Or:
1. Unlock you Kenmore dishwasher control panel by pressing and holding "Heated Dry" button for four seconds.
2. Press a series of four buttons in quick succession: "Heated Dry," "Normal Wash," "Heated Dry," and "Normal Wash" to instruct it to run a short diagnostic test.
3. Wait for two minutes while it runs the test.
4. Press the "Cancel/Drain" button once it has completed its test. This should reset the dishwasher control panel and stop the "Clean" light from blinking repeatedly.