I have a kenmore elite he 3t frontloading washer which during the spin cycle has a clog somewhere within the machine as I have unhooked the hose in the back & flushed thoroughly. I see no access inside the machine to check for a clog or where a filter would be located. I appreciate any help given thank you

Are any codes flashing in the display? This can help determine the problem greatly. This usually would cause f02 to flash in the display. Small items can slip through and lodge in the pump especially baby socks, footies, knee high hose etc. If those items can get into the pump they can lodge anywhere. This will cause the machine not to drain or spin. If you think this is the problem you can check the pump/filter using the document instructions below. Be sure to unplug the machine and have plenty of towels on hand as this could be a bit of a wet mess. Good Luck.