PDA

View Full Version : 1990 Honda Accord not starting.


Jackel402
Jun 10, 2007, 01:04 PM
I have a 1990 Honda Accord LX and just recently it stopped running. When ever I try to start it all it does is just turn over. And I don't believe I have spark either. Now I have already took a quick look online and the most common fixes are Fuses, Main Relay, Igniter, Ignition Coil. And I have replaced all of those. I'm at a dead end here. I don't know what to try next. Any suggestions?

TxGreaseMonkey
Jun 10, 2007, 03:18 PM
. Reading sections A and B should help:

https://www.askmehelpdesk.com/cars-trucks/faq-how-troubleshoot-repair-maintain-hondas-46563.html

. Make sure you test all under-dash and under-hood fuses with a test light or multimeter. Pay particular attention to the ACG (S) (15 A) fuse, in the under-dash fuse box. Here's how:

https://www.askmehelpdesk.com/cars-trucks/faq-how-troubleshoot-repair-maintain-hondas-46563-3.html#post252145

. Be sure and check for codes, answer the 3 basic diagnostic questions, perform the K-Test on your ECM, and check for spark.

Jackel402
Jul 1, 2007, 01:08 PM
I have a 1990 Honda Accord LX and just recently it stopped running. When ever I try to start it all it does is just turn over. And I dont believe I have spark either. Now I have already took a quick look online and the most common fixes are Fuses, Main Relay, Igniter, Ignition Coil. And I have replaced all of those. I'm at a dead end here. I dont know what to try next. Any suggestions?
I hope doing this bumps the message. My Honda still isn't starting. Ive already replaced the fuses, Main Relay, Igniter, Ignition Coil. I have spark but no gas is getting through. Ive checked the pump by connecting it directly to the battery for a sec to see if it turns on and it works. But when the pump is in the tank and I turn the ignition to ON the pump should come on to pressureize right? If so I can't hear it turn on. Right now the only two things that I can think of is either the fuel filter is blocked or while the pump is connected its not getting power.

TxGreaseMonkey
Jul 1, 2007, 01:24 PM
. Did you check for codes?
. Provide the answers to the 3 basic diagnostic questions.
. What were the results of the K-Test on your ECM?