Terminal block replacement for GE stove.
If the clips fit into the terminal block where
Does the wire go. Only one wire with two clips
On either end.
Or do you just splice the wires to the existing wires.
Bad burner

https://www.bing.com/videos/search?q=how+to+replace+terminal+block+on+ge+oven&docid=608021630722705904&mid=45CAAF99D94CA5F1E6F145CAAF99D94CA5F1E6F1&view=detail&skipintro=1&FORM=VIREHT

Looks like it simply plugs into the new block pastor. I cannot see from your picture the wire you talk about so if you could explain where it came from that would help. Was the wire broken from one of the clips?

Review your wiring as there are only TWO that go to the block.

Funny thing the burner started working again . I'll keep this new part for a while.
It is just one single wire with two different clips on each end. If you insert
Them into the block what about the other end of the wire. You would still
Have to cut it, unless you splice the cut wire to the existing wires.

Look on the bottom of the block, between the wires shown. It appears there are 2 spaces where the wires push fit.

Looks like it. If that is true. Do you have to splice the other end to the existing wires
Stripping off the insulation ?