markdunbar
Jun 8, 2009, 08:59 AM
Whirlpool gas dryer starts, the igniter glows, gas is ignited and then the flame goes out and stays off. Vents are not blocked, the flame sensor is new, the thermal fuse is new. The igniter glows through flame ignition and then shuts down (not sure it this is normal) and I'm not sure if the gas is shut off after flame ignition (hard to tell). Any thoughts?
hvac1000
Jun 9, 2009, 07:00 AM
You might test the coil at the gas valve there are two of them. You will want to test the main coil as listed here under the cabinet and the parts catalog image. Number 70 on the parts list the one with 2 terminals. Check for continuity and go from there.
Part Advantage :: Category Search (http://www.partadvantage.com/store/categories/wp/LGR7646EQ1)
OR number 13 on this image
http://www.partadvantage.com/catalogimage.php/BF2F694F.gif?geometry(1000x1000)