I just purchased a Harbor Breeze 69" (twin blades) ceiling fan and am having problems with the wiring.

I have black, red, white, and green from the ceiling box and black, white, and blue to the ceiling fan. The remote transmitter has black and white on the inbound side and black, white, and blue on the outbound side.

The light is a halogen bulb.

There was a ceiling fan/light previously installed by an electrician and black/black, white/white, and red/blue was the way it was hooked up.

There are two wall switches - one for the fan and one for the light.

I tried the same wiring arrangement and the fan works but not the light.

How should I wire it up?

And do I have to use the transmitter/remote to make this work?

Thanks

You can try without the remote, I'm not sure if it will work:

Black-black, blue-red, white-white.

If that doesn't work, you may have to use the remote:

Black, white, blue, to black, white, blue on the transmitter

Black and white on the other side of the transmitter to black and white in the ceiling, cap off the red.

Ceiling fan wiring - Ceiling Fans N More (http://www.ceiling-fans-n-more.com/ceiling-fan-wiring.php)

Thanks. I 'll give it whirl - no pun intended.

We have the AirSpan 69" fan and the fans come lose after running then a while and tilt and the blade get stuck against the support arm. Tried Many times to tightening the flat washer and the same problem occurs. Is there a way to fix this. The fan is useless and could be dangerous. Thanks for you time.