Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
What is the maximum span for (2) 2x12 LVL beams?
[ 5 Answers ]
I am finishing my basement and was wondering about the span rating for the (2) 2x12 LVL beams that support the one section. It is currently supported in the middle of the 11' gap with a support pole. I was wondering what I would have to do to remove the support pole? Some have suggested added...
How do I make a header to span about 8' where I want to take out a load bearing wall?
[ 4 Answers ]
Title: Header to replace a load bearing wall I want to make a header, 2x10, 1/2" plywood, 2x10, 1/2" plywood, 2x10, nailed and glued together to span about 8'where I wish to remove a load bearing wall. Will the header support the weight?
Header with mid-span supports
[ 4 Answers ]
Hi all, Will be framing for a set of 3 windows installed side-by-side with 3 transom windows above (6 windows total). I'd like to use 1 header over the entire set with single 2x4s between each window. Maybe this is common and perfectly fine, or maybe it changes the way the header is going to...
How far will a 2x12 span
[ 1 Answers ]
I am trying to use 2 2x12s as a header put a 4x4 at each end 16ft will I be OK its an over hang on the house about 5.5 feet wide and 16 ft long
Span of 2x12
[ 1 Answers ]
I'm building a deck and was wondering how far I could span 2x12 joists View more questions Search
|