Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Screws below the level of the shower curb
[ 4 Answers ]
In course of constructing my shower pan, I realized I would need to add a fourth 2x4 to my shower curb. This addition was to accommodate the need for an exceptionally thick mortar bed (drain located at the end of a 60" shower). Anyway, the new curb height is now slightly above the screws securing...
A/C pan rusted and leaks, coil rusted
[ 3 Answers ]
I have just been told that my pan is rusted out and dripping into an aux. pan and that my coil is rusted and I should get a new unit. I was told that in 2010 freon regulations will change and if I just change the coil and then I need freon, I will have to replace the coil again to conform to the...
Shower faucet handle -has no screws? Remove?
[ 2 Answers ]
My shower faucet handles are Elger shiny chrome 1 piece handles. Shaped like a fluted ball with a cylinder beneath it. They have no screws holding them on. They do have a small rectangular "cross pin" looking thing. It can't be driven out, and it may be a spring that snaps in an indentation?...
Removing screws in old Stanadyne shower faucet
[ 2 Answers ]
How do I remove highly resistant screws within an old Stanadyne shower faucet?
Shower drain rusted unable to remove, help.
[ 3 Answers ]
I've looked at the WingTite shower drain instructions and they seem pretty much clear. Before I proceed I would like to know if these steps will work on my drain because before I found their website I tried to remove the drain by gaining access from the bottom of the shower and could not. I found... View more questions Search
|