Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Pressure switch for 2 wire single phase submersible pump.
[ 3 Answers ]
Getting ready to pipe in a new pressure switch for a Franklin submersible pump, and I'm having trouble understanding how to set low pressure pump on, and high pressure pump off limits. Anyone know how to choose and set these limits?
I need help in wiring a submersible well pump
[ 1 Answers ]
I purchased a 1.5 HP 3 wire submersible well pump. I was surprised to see the four wires as follows: 1 - Black 1 - Blue 1 - Yellow with a green stripe 1 - Brown Not at all what I was expecting in the normal setup of 1 each red, black, green, and blue. Can someone help me figure out how...
Testing pressure control switch on submersible pump
[ 0 Answers ]
Testing the pressure control switch I found that the ground had 1/2 volt. Just wondering why that would be?
Water pump pressure switch wiring
[ 2 Answers ]
We lost water pressure in our house last night. We have a well pump 360 feet down. My 1st thought was the well pump has finally failed. I though a moment and remembered there is a pressure switch in the basement so decided to check that. The pressure read only 30. That seemed a little low. I...
More Problems . Pressure Switch Submersible Well
[ 5 Answers ]
Hi - My pressure switch is short cycling or rapid cycling. Basically the points in the pressure switch are cutting on and off at a very, very rapid pace. Something is sure to be damaged soon. I had a plumber out the other day, but it would not do it when he was here. The pressure switch is... View more questions Search
|