Ask Experts Questions for FREE Help !
Ask
    mrxwesty's Avatar
    mrxwesty Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jan 20, 2010, 05:53 PM
    7.3 diesel IDM fuse blows as soon as key is turned to on position
    I have checked all harnesses from valve covers to ecm I was told IDM controler was on fire wall under dash under seat on floor plan?
    Thanks M
    KUXJ's Avatar
    KUXJ Posts: 975, Reputation: 97
    Senior Member
    		  
    #2

    Jan 20, 2010, 07:55 PM

    Hi! mrxwesty, welcome to AMHD :)

    It would help if we had a little more information.
    • Year
    • make
    • model
    • Left/right hand driver?

    On a '99 Ford Powerstroke it's...
    Drivers side front inner fender well, the IDM is located just rearward of the highest spot on the wheel well.

    96 CC F350
    Inside of the passengers fender, near to the hood spring.

    What makes you think it's a blown fuse, maybe it's a no start situation?

    See:
    PowerStroke diagnosis

    K
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Fuse blows [ 2 Answers ]

I have a craftsman 25hp 48in cut the fuse blows after the clutch has been engaged. Sometimes right after, sometimes a few minutes will pass before it blows... Any suggestions?

Craftsman trying to start while key is in on position? [ 3 Answers ]

I have a craftsman 44" 16hp riding mower and I have peplaced the starter, solonoid, and ignition switch. I knew the starter had been out for a while and that got it started only by jumping acrossed th solinoid due to the fuse blowing every time the key was turned on, the wires are in good shape and...

My furnace blows the fuse [ 1 Answers ]

I have a Comfortmaker Furnace (approximately 1998/99) and the fan will not turn on allow the furnace to heat. When I try to turn the furnace on it blows a 3 amp fuse at the blower motor. I removed the fuse and jumped it and all it will do is make a faint buzzing noise and not turn on. I can see...

Microwave blows a fuse [ 21 Answers ]

Every time we use our microwave it blows the fuse after about 30 to 45 seconds max. We have a Sharp Carousel R426. It's plugged into a GFCI receptacle that is the only receptacle on a 15 Amp breaker. Do I need a 20 Amp breaker for the microwave? Is there something that could be wrong with this...

Fuse blows [ 10 Answers ]

As soon as I turn the key to the on position the 30 amp fuse blows. I have a Craftsman 12.5 lawn tractor. The battery is new. I'm not sure what's wrong. Thanks for any advice. Jeff C.

View more questions Search