Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
No hot water from electric water heater
[ 18 Answers ]
I've installed a new 55 gal hot water heater. My old water heater had only two wires black and white. The new water heater came with three wires a yellow, blue and black. I've attached the blue and black to the incoming black wire and the yellow is attached to the white incoming wire. I...
New electric water heater low hot water pressure
[ 1 Answers ]
I just replaced an old electric hot water heater, roughly 10+ years old, with a new one. This was done in the early am, before noon. It is now evening, after 6pm EST. and I've noticed two things. 1) My hot water pressure is now low in all of my faucets, but the cold water is fine. 2) The water...
Replaced electric water heater Atlanta area, but no hot water
[ 14 Answers ]
The old water heater died. Bot one (38 gals) at HD. Installed exactly like the old one was as follows--3 CPVC pipes come out of wall. Two are joined. Before they are joined one has a valve. After they are joined there is a second valve. The pipe is connected to the cold side of the heater using...
Electric Hot Water Heater
[ 1 Answers ]
On Thursday, December 6th, 2007 our pump house for our well froze up. When water was finally restored my hot water heater didn't work. I get nothing, not a gurgle or grind. When I turn on the hot water spigot water comes out so I know water is flowing through the hot water heater, but it is not...
Electric Water Heater
[ 7 Answers ]
Howdy all again, here's another question. If you read my previous post about Water Circulator Woes, we're going to move upstairs now. My 20 gal electric water heater is pulling too much power. It's discoloring the electrical faceplate, and it actually burnt through it's power cable. But it... View more questions Search
|