Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Replacing a Lennox Thermostat with a Lux Thermostat
[ 3 Answers ]
I have an older analog Lennox thermostat and am replacing with a Lux ATX500 thermostat. The Lennox thermostat connections do not match those on the Lux. The Lennox is a 6 wire connection with terminals: F, V, R, X, Y, M The Lux has terminals: G, Y, W, RH, RC The Lux instructions are very...
Lux ultra 1000 thermostat
[ 3 Answers ]
I have a Lux Ultra 1000 Thermostat, I think that the room temperature it shows is off. It will read 68, but a second thermometer (placed a few inches below it) reads 64. Is there anyway to calibrate the unit, or should I just get a new one?
Replaced lennox t-90 t-stat w/ hunter just right -still not fixed
[ 1 Answers ]
Original problem was my blower was kicking on for about 10 seconds without the furnace lighting up and sending heat with the blower then it would cut off about 10-20 minutes later the furnace and blower would run its normal heating. Changed the lennox for a hunter just right digital and had some...
Lennox A/C 10AC30-3P Evaporator replaced, Problems still. Bad installation?
[ 1 Answers ]
We have a Lennox air conditioner that has had a leak the previous 2 years. It is a 10AC30-3P, installed new in a new home in 1994. Had no trouble till 3 years ago. The 1st year, the serviceman said a coolant leak was from a loose nut on the outside unit and it was tighten by the serviceman and... View more questions Search
|