Ask Experts Questions for FREE Help !
Ask
    Cub Cadet's Avatar
    Cub Cadet Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Mar 30, 2008, 09:04 AM
    1620 cub cadet
    Hi I need help with my 1620 cub cadet can anyone tell me how to bleed or purge air out of hydrostatic unit?Thanks
    MOWERMAN2468's Avatar
    MOWERMAN2468 Posts: 3,214, Reputation: 243
    Ultra Member
    		  
    #2

    Mar 30, 2008, 05:11 PM
    Good Luck.
    SkipB's Avatar
    SkipB Posts: 41, Reputation: 2
    Junior Member
    		  
    #3

    Apr 2, 2008, 01:33 PM
    I'm not familiar with the cub cadet system, but every hydro I've worked on has recommended filling the hydraulic oil reservoir and turning the engine over for fifteen or twenty seconds to circulate the oil and charge the system. On gas units remove the spark plug and crank the starter. On diesels disconnect the fuel shutoff solenoid and crank the starter. Make sure you recheck the oil reservoir afterwards and fill to the proper level.
    MOWERMAN2468's Avatar
    MOWERMAN2468 Posts: 3,214, Reputation: 243
    Ultra Member
    		  
    #4

    Apr 2, 2008, 03:55 PM
    Good Luck!
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Cub Cadet PTO problems [ 2 Answers ]

:( We have a Cub Cadet 1050 LT, we recently replaced the PTO belt. When I start mowing, if I am going slow, everything is fine, as soon as I speed up, the PTO shuts down. I have to re-engage the PTO and drive super duper slow. Anyone have an idea?

Cub Cadet steering problems [ 1 Answers ]

How do I aline steering arms on cub cadet 1554 so that one wheel does not go in one direction and the other wheel in the opposite direction? Steering links are measured and seem to be the same length and straight, but when you start driving front tires get out of aline and go in opposite direction.

Cub cadet 1800 [ 1 Answers ]

My cub cadet makes a noise in the transaxle when I am going up hill and stops moving it sounds like a grinding noise can anyone help?

Cub Cadet Wheel Removal [ 4 Answers ]

The rim on my Cub Cadet 1225 Garden Tractor is slightly bent, and I'd like to remove it and get a replacement. I've taken off a plastic hub cover, removed a bolt, and metal sleve, and it appears that is all that is holding it on. When I try to pull the wheel off, it still doesn't budge. Am I...

Cub Cadet 1200 [ 3 Answers ]

Hi guys it's me again! I recently traded around for an older Cub Cadet 1200, seems I over looked some problems but am happy over-all with my trade. My question is what does it mean when 1st starting the engine it smokes blue for a couple of minutes and then clears up. Valves? Rings? It...

View more questions Search