Search:

I was wondering if Cutler Hammer made a part to convert a main breaker load center (CH) style, to a main lug panel. If so, does anyone know the part number or can you refer me to a location where I...

Can I use a 10 kAIC main breaker in a main disconnect or does it have to be a 35 kAIC main breaker? I have a 10 kAIC, 225 amp breaker on hand, and I did not want to have to buy a new 225 amp 35 kAIC...

Well, since the top edge of the 3” ABS is just one half inch below the floor surface, could I just put down a closet flange ring, screwed into the concrete, and then use a wax ring with a longer...

I have a 3" abs plastic pipe in my basement concrete floor, that is just below level with the floor. It is recessed about 3/8 to 1/2 inch below the floors surface. I need to put a toilet back in...

My aerial line comes from my meter (meter on pole) and ends just before it goes into the conduit on the side of my house. This is where 6 runs of this wire start by being clamped to the end of the...

I know it is much larger than #14. It is feeding a 100a main breaker & it has 7 strands.

The wire running to the main breaker in my panel has the following written on the side of the wire. I am trying to figure out what gauge it is. The wire says, "GENERAL CABLE 3 TYPE THW 600V MTW...

Does anyone know if any of the big box stores or another national chain carry the oatey abs/pvc green transition cement? Thanks

Are you using a harmonic balancer puller? Usually there are two to four holes in the face of the pulley. These holes are used to thread the bolts of the puller into. Have you been using a puller?

The 6.0 ford was plagued with problems. I don't want to be the barrer of bad news, however most of the problems associated with that engine were injector related.

What is the best way to move a shower drain in the basement floor. I am doing a remodel in my basement and the shower drain will have to be moved. I was wondering what the best way to remove the...

I have 10-3w/g cable running from my home breaker box, to my garage into a plug for a welder. I was wondering, since I don't use the welder plug anymore, could I run that 10-3 cable into a small...

I had heard there was a liquid you could buy to assist in indoor concrete removal. I was told you could drill holes in a line and pour this stuff in the holes and it would then expand and break the...