Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Sears Model 917.256524 Lawn tractor 15.5 HP
[ 9 Answers ]
I have a 15.5 Hp Craftsman lawn tractor. It starts fine but when you push the blade lever up to engage the blades the mower dies. Also if you let out on the brake/clutch pedel the mower stops. Note: the blade safety switch is OK and so is the clutch safety switch as is the seat safety switch. Any...
Smell of burning rubber after changing drive belt on Sears Garden Tractor
[ 3 Answers ]
I changed the Motion Drive Belt on my 20hp 1999 Sears Garden Tractor. After changing, tested it, and it has plenty of "pick up" and runs good. However, after a minute or two, smell burning rubber. Is this normal, perhaps a "break in" period, or is it likely I have done something wrong?
Old Sears furnace
[ 1 Answers ]
We have an older(at least 20 years that we know of) Sears series 600 furnace. Recently the blower started coming on for 10 to 15 seconds than shutting off. After 3 or 4 times of doing this furnace will run through a normal cycle. Also ,sometimes the blower will come on as soon as the burner lights...
Sears elite dryer
[ 2 Answers ]
Sears gas dryer will run but no heat. It is a front load about 5 years old... Any help out there?
Sears Craftsman Lawn Tractor
[ 4 Answers ]
I have a 10 HP Craftsman lawn tractor that will not move. The clutch works and it goes into gearbut the flat wheel spins and the gear wheel seems too have not enough pressure on it to move. Could this be just a loose drive belt? Thanks, Charlie View more questions Search
|