Ask Experts Questions for FREE Help !
Ask
    adkhkr's Avatar
    adkhkr Posts: 64, Reputation: 1
    Junior Member
     
    #21

    Nov 24, 2019, 07:04 AM
    Got sidetracked this week but here is the sinks completed less the venting...I'll message you, thanks!

    Sent from my SM-N975U1 using Tapatalk
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
     
    #22

    Nov 24, 2019, 09:07 AM
    Nice job...looks great!
    adkhkr's Avatar
    adkhkr Posts: 64, Reputation: 1
    Junior Member
     
    #23

    Dec 1, 2019, 12:08 PM
    Except for the rest of the pex supply lines, this wall is done. This was a tough one.

    Sent from my SM-N975U1 using Tapatalk
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
     
    #24

    Dec 2, 2019, 08:25 AM
    It was a lot of work, no doubt...drilling large holes is a blast, huh??

    You did a nice job here...very clean.
    adkhkr's Avatar
    adkhkr Posts: 64, Reputation: 1
    Junior Member
     
    #25

    Dec 6, 2019, 01:21 AM
    For the toilet plumbing, does this look right?

    4x3 closet bend to 3x3x2, with the 2in vent going up the wall

    Sent from my SM-N975U1 using Tapatalk
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
     
    #26

    Dec 6, 2019, 05:30 PM
    Tee goes in the other direction (flip it)...with the flow so water/condensation build up flows down the drain.

    Otherwise, fine.

    I like to use a 3" 90 and then install a 4"x3" stainless steel ringed closet flange but what you have there is fine as well.
    adkhkr's Avatar
    adkhkr Posts: 64, Reputation: 1
    Junior Member
     
    #27

    Dec 7, 2019, 08:15 AM
    Slow but steady lol

    Working my way towards tackling the fernco fitting that needs to go.

    Sent from my SM-N975U1 using Tapatalk
    massplumber2008's Avatar
    massplumber2008 Posts: 12,832, Reputation: 1212
    Senior Plumbing Expert
     
    #28

    Dec 7, 2019, 12:36 PM
    You follow directions well....nice job.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Live in Condo and masterbath light fixture has water in it this morning [ 4 Answers ]

Live in a condo(middle), this morning notice water in the ceiling light in the master bathroom. Should I call plumber or electrician for this problem.

Plumbing-bathroom remodel [ 1 Answers ]

My current drain pipe for the bathtub is left, however, I bought a tub with center drain. Is it possible to get to the left drain without replumbing?

Plumbing vent question on a remodel. [ 6 Answers ]

I am remodeling my home and need to tie into the existing vent and drain of a toilet - BUT - there is NO existing vent on that toilet and the soil pipe drops vertically from the toilet. So, can I a vent tie into that vertical pipe? If not, how do I correct this? If so, how far below the toilet can...

Kitchen remodel Plumbing stack in the way [ 7 Answers ]

1. The plumbing stack runs through a wall that I would like to remove 2. I pulled down the drywall ceiling and I see it runs from the basement straight up through the kitchen wall I would like to remove, then 90's towards the back of the house and then to a T joint for the shower drain which is...

Foul odor from 2nd floor masterbath sink [ 1 Answers ]

I live 2 story house with 3 full bathrooms. In our masterbath whenever we turn on any one of the two sinks, there is a foul odor emitting form the drain for the first 10 to 20sec while the water is running. This will happen every time we use the sinks. It only happen in the master bath. What is the...


View more questions Search