Ask Experts Questions for FREE Help !
Ask
    indians's Avatar
    indians Posts: 1, Reputation: 1
    New Member
     
    #1

    Feb 28, 2019, 09:01 AM
    Which of the following combinations of bends can be used in a conduit run?
    Which of the following combinations of bends can be used in a conduit run?
    A. Two 90-degree, four 45-degree, and one 30-degree
    B. One 90-degree, six 45-degree and one 30-degree
    C. One 90-degree, three 45-degree, and four 30-degree
    D. Two 90-degree, two 45-degree, and four 30-degree
    tkrussell's Avatar
    tkrussell Posts: 9,659, Reputation: 725
    Uber Member
     
    #2

    Feb 28, 2019, 12:53 PM
    Which one of the four choices was discussed in the class?
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
     
    #3

    Feb 28, 2019, 01:53 PM
    Read the NEC Handbook. Look under "conduit"
    donf's Avatar
    donf Posts: 5,679, Reputation: 582
    Printers & Electronics Expert
     
    #4

    Feb 28, 2019, 02:24 PM
    This is simple, only one set of bends can be used. Look it up and then do the math!
    hfcarson's Avatar
    hfcarson Posts: 1,003, Reputation: 49
    Ultra Member
     
    #5

    Mar 4, 2019, 09:59 AM
    If I gave you the wrong answer, how would you know?
    and who would you blame?
    Try to answer the question and then ask for help, I promise
    it will be worth it...

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

HD 39 Stapler now bends one end of staple [ 0 Answers ]

I found how to replace the staples on this site (quite a job actually) and now the staple doesn't bend over neatly on one end. I checked and there is no jam. Put them back in as described for Swingline 39 HD Stapler and same issue - worked perfectly before changing the staples (also Swingline #39...

Retaining wall cap stone bends [ 1 Answers ]

I am having trouble making the cuts for the cap stones on a 90 degree bend using cst block. I have a straight run that makes a sharp 90 degree bend at the end of the wall. I need the caps to line up on the front and back of the cap before it all the way around the bend evenly. I can't have any...

Minimum distance between emt conduit for data and emt conduit for power [ 1 Answers ]

Minimum distance between emt conduit for data and emt conduit for power?

Sewer line drop and bends [ 8 Answers ]

I have a sewer line that runs about 75 feet then I have a 45 degree bend to the rest of the line which is about another 75 feet. 2 questions: first, there is plenty of drop as it is downhill all the way, but can it drop too fast? If so what is the maximum drop I would want? Second, is the 45 degree...


View more questions Search