Ask Experts Questions for FREE Help !
Ask
    bamautk's Avatar
    bamautk Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 30, 2017, 01:03 PM
    #60-100394-02 gas valve
    How do I ignite the gas furnace when I cannot find the gas control knob?
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Oct 30, 2017, 01:55 PM
    Never saw a HW heater without some type of control.

    Is this yours? Looks like a module plugs in the top. Note ON and OFF.
    Honeywell says "Product is discontinuedNo alternate products can be found at this time".





    https://www.grainger.com/product/RHE...ral-Gas-34VH45
    talaniman's Avatar
    talaniman Posts: 54,327, Reputation: 10855
    Expert
    		  
    #3

    Oct 30, 2017, 02:16 PM
    You don't light it, you have a tech come out and troubleshoot your electronic igniter and flame sensor components.



    See the on/off at the top... if indeed this is your unit. This is the one from Sears.

    https://www.searspartsdirect.com/par...1&sid=SPDxBING
    talaniman's Avatar
    talaniman Posts: 54,327, Reputation: 10855
    Expert
    		  
    #4

    Oct 30, 2017, 02:46 PM
    http://i.ebayimg.com/images/i/181602...-1/s-l1000.jpg
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Leaking hot water heater drain valve after new brass valve installed [ 2 Answers ]

I had a leaking (plastic) drain valve on my GE hot water heater. It was leaking from the inside of the valve. The small rubber washer was crimped. I installed a new brass drain valve that I purchased from home depot using teflon tape. The valve now leaks from the threads of the tank/valve. I...

Taco zone valve 571-2. Water flow not like the arrow in the valve's body. [ 0 Answers ]

I had a Taco zone valve 571-2 installed recently. Later I noticed that the valve is installed with the arrow in body of the valve pointing to the opposite direction of the actual water flow. I called the plumber and he said that this is not a problem and no damage will occur to the valve, the...

I have a early 90's Kohler shower valve and rounded out the cold stem valve seat. [ 2 Answers ]

Should I drill then retap the threads? Thanks!

I'd like to install a ball valve on main water line will a "Viperlok" valve work? [ 1 Answers ]

I know sweat soldering a ball valve is best, but will a "push-ft" compression "Viperlok" brand ball valve work?---My pipes are old copper, and have a few minor scratches and pits---I also noticed a seam running down one side of pipe. This water line runs out into garden, but valve is in the house....

Can I solder outlet side of a ball valve if the valve is closed and under pressure? [ 0 Answers ]

Can I solder outlet side of a ball valve if the valve is closed and under pressure?

View more questions Search