Ask Experts Questions for FREE Help !
Ask
    johna123's Avatar
    johna123 Posts: 2, Reputation: 1
    New Member
     
    #1

    Dec 2, 2016, 07:23 PM
    Inducer motor
    My inducer motor comes on for a few seconds then stops and repeat the cycle. I pulled the vacuum hose from the pressure switch and the inducer runs normally. While it runs I manually close the pressure switch (sucking on the hose) and the motor stops. Did this several times, same result.

Check out some similar questions!

I took off inducer motor mounting bolts but can't pull motor out [ 2 Answers ]

I can't pull out inducer motor for bryant plus 90 furnace. I have mounting bolts off but shaft is holding me mack. How do I get it to release?

What is a inducer motor [ 1 Answers ]

What is a inducer motor

Inducer motor? [ 1 Answers ]

When I turn my thermostat on at first I hear a humming then it blows hot air then cold air. I was told I need an Inducer motor? Does that sound correct?

How much for an inducer motor? [ 1 Answers ]

How much should it cost to replace a goodman inducer motor that is humming?

What is the inducer motor [ 3 Answers ]

I have a bryant 395C gas furnace and the inducer motor assembly is making noise. The motor seems fine and the furnace operates normally, but there is a plastic wheel attached to the end of the motor that is rattling when the motor runs. I've looked at pictures of many inducer motor...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.