Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Leaking hot water heater drain valve after new brass valve installed
[ 2 Answers ]
I had a leaking (plastic) drain valve on my GE hot water heater. It was leaking from the inside of the valve. The small rubber washer was crimped. I installed a new brass drain valve that I purchased from home depot using teflon tape. The valve now leaks from the threads of the tank/valve. I...
Taco zone valve 571-2. Water flow not like the arrow in the valve's body.
[ 0 Answers ]
I had a Taco zone valve 571-2 installed recently. Later I noticed that the valve is installed with the arrow in body of the valve pointing to the opposite direction of the actual water flow. I called the plumber and he said that this is not a problem and no damage will occur to the valve, the...
Hot water problem - faulty check valve or mixing valve?
[ 8 Answers ]
Hi, We have a weird problem with hot water running cold in our apartment. At all of the faucets and taps we only get hot water for a minute or two and have to turn off the faucet/tap for 30 seconds and back on again to get hot water. Then the same thing happens again. To get continuous hot...
I'd like to install a ball valve on main water line will a "Viperlok" valve work?
[ 1 Answers ]
I know sweat soldering a ball valve is best, but will a "push-ft" compression "Viperlok" brand ball valve work?---My pipes are old copper, and have a few minor scratches and pits---I also noticed a seam running down one side of pipe. This water line runs out into garden, but valve is in the house....
Cold water pressure relief valve leaking, not the TRP valve
[ 5 Answers ]
Hello. Cold water pressure relief valve start to drip water through the drain pipe. I replaced it with a new one but it is also dripping water. I have reduced water pressure in the house to the minimum by turning main water supply valve but it still leaking. Thanks for your help. View more questions Search
|