Ask Experts Questions for FREE Help !
Ask
    aselden's Avatar
    aselden Posts: 3, Reputation: 1
    New Member
    		  
    #1

    May 24, 2015, 07:53 PM
    Deere 316 no reverse
    John Deere has forward hydro, but no reverse.
    Any suggestions would be appreciated.
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #2

    Jun 25, 2015, 04:57 PM
    Hi,
    A 316 should an "S" (or "Z") shaped handle on the dash. If you have no reverse then this adjusted incorrectly.
    Peace,
    Clarke
    DG's Avatar
    DG Posts: 1,375, Reputation: 109
    Ultra Member
    		  
    #3

    Jun 26, 2015, 11:53 AM
    Check the reverse check valve on top of the transmission .
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #4

    Jul 26, 2015, 04:41 PM
    Hi,
    Agree with DG as I have seen the stick. There are two valves on top of the transaxle, one for forward and one for reverse. They are brass in color and have small push buttons in their center. They are spring loaded and the pin should be up or out, depending on your way of describing it.
    Peace,
    Clarke
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How to get L110 John Deere tractor in reverse? [ 0 Answers ]

Where is reverse switch for John Deere mower L110?

Seat switch on john deere 316 troublshooting [ 2 Answers ]

I have a John Deere 316 tractor which will start sporadically. Scenario: Engage the foot pedal to start tractor. No solenoid click, no turning over of motor. The first time it occurred, I cleaned the seat switch and it started. Happened again and in attempting to get it started, I leaned...

John deere 316 dies - starts later [ 0 Answers ]

Hi I have a John Deere 316 with 2 cyl Onan. It starts fine, runs for 10-15 minutes, then dies. It turns over, but won't start until later. Ideas? Thanks!

John Deere 316 cranks but shuts off when put in gear [ 1 Answers ]

When I start my John Deere 316 it cranks fine, but when I put it in gear it shuts off. Does the same thing when I try to engage blades. Thanks!

John Deere 316 dies when hydro engaged [ 2 Answers ]

I have a 1986 John Deere Model 316 riding tractor. I have a problem with a safety switch somewhere that I cannot seem to locate. When I start the motor and try to engage the hydrostat or the pto, it dies. I have replaced the switch on the hydro control and cut the wires on the seat switch and...

View more questions Search