Ask Experts Questions for FREE Help !
Ask
    kdwells1958's Avatar
    kdwells1958 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 14, 2014, 09:29 AM
    Expansion Valve Problems
    410-A system, low suction. 50psig discharge 240psig ambient. 75*F,unit icing up back to the compressor,evaporator iced,indoor coil encased in Sheetmetal, not accessible. What do I, do... TXV problem.
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Jul 14, 2014, 11:28 AM
    Suggest you repost this under "Home and Garden"-- heating and air conditioning. However, if you determine it is the TXV, you will need to open the plenum. Then you can install a slightly larger repair panel and use ductwork adhesive to seal it.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

r410 expansion valve conversion [ 3 Answers ]

Can a condensing unit that runs on R22 run on R410?

Pressure relief valve has been suggested ,can this valve be fitted to the expansion p [ 0 Answers ]

Installing a expansion valve [ 1 Answers ]

HI, I have a cental a/c in my home it is a york 3ton. The freon is controlled by an orfice. I was told that an expansion valve is much better. The reason for the change the system will not cool like I think it should. Even when it was new it did not work that well. I have a 1280sf raised ranch. I...

View more questions Search